Description of the 3 manual reset procedures for AIR series
There are three distinct reset levels available in the AIR series. The appropriate procedure to use will depend on the specific issue you are encountering.
All Reset procedures will affect all monitors connected when they
are executed.
Note: It is also possible to execute these resets from the AIR CONTROL software if you have the cable package and a connection to a PC or MAC
1. Clear Monitor Settings
The Clear monitor settings reset procedure will reset
all global and local parameters for all connected monitors. Preset and network settings are not affected.
To access this Reset procedure, press and hold the ENTER key on the System Controller monitor while powering it up. Use the arrows to chose the reset procedure and press ENTER to confirm.
2. Reset All Settings
The Reset all settings reset procedure is a “factory reset” that will delete all global and local parameter settings as well as preset and network settings.
To access this Reset procedure, press and hold the ENTER key on the System Controller monitor while powering it up. Use the arrows to chose the reset procedure.
This procedure is recommended when relocating the system to a new environment or if you are experiencing unexpected behavior from the system.
A new Setup procedure with monitor task assignment should be performed.
3. Clear Setup for entire network
The Clear setup for entire network reset procedure
will clear the network settings for your entire AIR system. All connected monitors will be reset to default settings.
To access this Reset procedure, proceed as follows:
► From the home screen, press the ENTER key.
► Press the DOWN key until “Setup menu” is displayed.
► Press the ENTER key.
► Press the DOWN key until “Clear setup for entire
network” is displayed.
► Press the ENTER key.
“Accept to clear network setup?” is displayed.
► Press the ENTER key to clear the setup or press
the EXIT key to discard
A new Setup procedure with monitor task assignment should be performed.